TBS Lucid H7 FC 2-8S Dual Camera Input ICM42688 x 2 (duo gyro) Flight Controller – 30x30mm – NDAA

Specifications:

• • MCU: STM32H743VIH6 running at 480MHz, with 1MB RAM and 2MB Flash.
  • Gyro: ICM42688 x 2 (duo gyro)
  • OSD Chip: AT7456E (SPI2)
  • Barometer: Infineon DPS310 connected via I2C2.
  • PWM Outputs: 13 channels, including a dedicated “LED” pad.
  • Blackbox (BB): Data logging equipped with a MicroSD card slot (SDIO)
  • UARTs: 7 total (1, 2, 3, 4, 6, 7, 8) signal inversion ready
  • I2C Buses: 2 available.
  • CAN Bus: 1 available.
  • Analog Inputs: 6 ADC channels (VBAT, Current, RSSI, Analog AirSpeed, Vbat2, Cur2).
  • LED Indicators: 3 LEDs (Blue, Green for FC Status, Red for 3.3V Power).
  • Breakout: SPI3 breakout available.
  • USB Interface: Type-C connector (USB 2.0 standard).
  • JST Connectors: 
    • 1x JST-SH1.0 8-pin (Vbat/G/Curr/Rx8/S1/S2/S3/S4)
    • 1x JST-GH1.25 4-pin (5V/CAN-H/CAN-L/Ground).
  • Dual Camera Input: Switchable inputs for two cameras.
  • Power Control: Switch for filtered 5V/Vbat output power.
  • DJI FPV OSD: Compatible via any spare UART port.

  Power Specifications

  • Input Voltage: 6 – 36V (2 to 8S LiPo).
  • BEC: 5V 2A continuous (3A max) & 9V 2A continuous (3A max)
  • LDO 3.3V: Supports up to 200mA.
  • Voltage Support: ADC Vbat2 pad supports up to 36V (1K:10K voltage divider).
  • Power Consumption: 200mA @ 5V with Betaflight, 150mA @ 5V with ArduPilot.

  FC Firmware Targets

  • ArduPilot: tba
  • BetaFlight: tba
  • INAV: tba

  Package Includes:

  • TBS Lucid H7 FC
  • FC-to-ESC cable (plug & play)
  • DJI O3 cable (plug & play)
  • 4pcs M3 rubber dampers
  • 4pcs M3x8 screws