HolyBro PM06 V2 Power Module

SKU: Q4-14345

Small Parcel

15-30 Days

Free

Special Line

Our courier will deliver to the specified address

7-15 Days

From $20

Courier delivery

courier will deliver to the specified address

3-5 Days

From $40

$27.99

Out of stock

Out of stock

Don't Miss Top Accessories

Description

This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.

    Checkout our BEC/PDB section and the rest of our Holybro Collection!

    Specifications:

      • Input voltage (14S version): 2S-14S
      • PCB Cont. Current Rating: 70A
      • PCB Burst Current Rating: 120A (<60 Sec)
      • Output: DC 5.2V & 3A Max 
      • Ouput Max Power : 18W
      • Voltage Divider: 18.182
      • Amperes per Volt: 36.364 

      Please Note: 

      • The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference.
      • This PM06 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM06D). 

      Mechanical Specification:

      • Dimensions: 35x35x5mm
      • Mounting hole: 30.5mm*30.5mm
      • Weight: 24g

      Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here.

      Package Includes:

      • 1 x  PM06 Power Module
      • 1 x  JST GHR 6pin 1.25mm pitch cable

      Specification

      Overview

      Weight0.028 kg

      Customer Reviews

      Reviews

      There are no reviews yet.

      Only logged in customers who have purchased this product may leave a review.